STEG QM500.1 Amplifier subwoofers The MGL-6 is engineered with

The MGL-6 is engineered with advanced materials and cutting-edge technology to deliver deep bass

Instead of a traditional subwoofer box

Installation is straightforward thanks to plug-and-play wiring that accepts both high-level (speaker) and low-level (RCA) signals

Specification Details (Estimated) Model AWAVE A8ii Active Subwoofer with Amplifier Driver Size 8″ (200 mm) active subwoofer Nominal Power (RMS) ~250 – 300 W RMS (active amplifier on board) Frequency Response ~40 Hz – 150 Hz (typical low-pass range for 8″ active units) Input Types High-level (speaker) and Low-level (RCA) Low-Pass Filter (LPF) Adjustable (around 50 – 150 Hz) Bass Boost Adjustable (0 – +12 dB typical) Phase Control 0°/180° switch or continuous Impedance Built-in amplifier — nominal load bridged to internal sub Signal-to-Noise Ratio ~>90 dB (good for active subs) THD (Total Harmonic Distortion) <0

STEG QM500.1 Amplifier subwoofers The MGL-6 is engineered withQuality monoblock suitable for enthusiasts of good sound. Class A B amplifier Power 4 ohm MonoWatt RMS 14. 4 Volt 200 x 1Power 2 ohm MonoWatt RMS 14. 4 Volt 350 x 1Power 1 ohm MonoWatt RMS 14. 4 Volt 500 x 1Power 4 ohm MonoWatt MAX 14. 4 Volt 450 x 1Power 2 ohm MonoWatt MAX 14. 4 Volt 600 x 1Power 1 Ohm MonoWatt MAX 14. 4 Volt 700 x 1 Input sensitivity: Volt RMS 200mV 6V LOW Pass 45Hz 255Hz 12dB Subsonic 15Hz 55Hz 12dB BASS BOOST 0 12dB 45 Dimensions: