Modular Incubator Chamber, Clamp (MIC-105N) Accessories By adjusting the flow rates

By adjusting the flow rates from the two tanks into the DFM 3002 while monitoring the oxygen percent with the GMS 5002

temperature & humidity sensors enable the GMS-5003 to integrate these additional sensor readings and convert the pO2 reading to an oxygen percentage (%O2) as seen on the display

It is commonly cited for its use in maintaining cell cultures in a hypoxic / hyperoxic environments

The DFM-3002 ships with 2 air filters

Modular Incubator Chamber, Clamp (MIC-105N) Accessories By adjusting the flow ratesMade in the US, out of premium glass fiber reinforced polycarbonate, this Modular Incubator Chamber Clamp has been custom designed to ensure a precise air tight seal every time. This clamp is an approved replacement for the previous generation incubators (with the steel clamps). Some adjustment may be necessary. Leave a note in the cart if you want it factory adjusted for the older units.