K20 K24 K Series Direct Water Pump Mount V2 Swivel Neck Thermostat Housing 16AN Bumper Installation:Difficulty: ★☆☆☆☆Time: 15–25 minTools Required:

Installation:Difficulty: ★☆☆☆☆Time: 15–25 minTools Required: Basic hand toolsInstructions: [View Here]

and intake/inlet hoses are constructed from 4-ply silicone

Its bold hexagonal design draws inspiration from motorsport aesthetics

Mirror polished finish for a clean engine bay appearance

K20 K24 K Series Direct Water Pump Mount V2 Swivel Neck Thermostat Housing 16AN Bumper Installation:Difficulty: ★☆☆☆☆Time: 15–25 minTools Required:All Hardware and fittings Included Our thermostat is designed to bolt directly to the water pump housing. It offers the same 16AN port to easily switch coolant fittings (1. 25" Hose 16AN). It also rotates 360 degrees allowing you to position the outlet to fit your setup perfectly. What is different with this housing is the two 3 8NPT ports located behind the thermostat. These allow you to properly run the recirculation hose and heat. This is important