APEXi Engine Metal Head Gasket VQ35HR, 97mm, T=0.9 (814-N404) 1809 The roto-molded housing is made

The roto-molded housing is made out of cross-linked polyethylene red and mounts directly into the factory headlamp cold air inlet location on the driverside to capture the coolest air available from the factory intake tract

Outlet temperature up to 30 lower than stock intercooler

Fits Copue Only

Description_ASC DO NOT FIT UPGRADE PADS TO REAR OF VEHICLE UNLESS SAME UPGRADE FITTED TO FRONT Description_ASM Rear Orangestuff Race Brake Pads FMSI D729 98 thru 2005 CHEVROLET Blazer 4

APEXi Engine Metal Head Gasket VQ35HR, 97mm, T=0.9 (814-N404) 1809 The roto-molded housing is madeThe A'PEXi metal head gaskets provide upgraded protection on high horsepower engines. Factory head gaskets cannot withstand the pressures of high output operation and often cause the engine to "blow." This condition is actually caused by a failure in the factory head gasket. A'PEXi recommends replacing the factory head gasket with a metal one before gasket failure causes more damage to the engine. The gaskets are all designed engine specific and