Laser Engravable Rubber - Super Thin Seals & Embossers 2770 - 16 black

2770 - 16 black

V Light Tubes

It will not work with any other type of paper or vellum

The pad is housed in an air-tight plastic container with two hinged covers -- one on top and one on the bottom so the pad is reversible

Laser Engravable Rubber - Super Thin Seals & Embossers 2770 - 16 blackApproximately . 060 or 1 16 thick (1. 5mm). 8 x 11 sheets. Must be washed with detergent and water after engraving. Confirm that your laser equipment is suitable for engraving stamp dies. Check with your laser equipment manufacturer to determine compatibility of equipment and software. The settings below are a good starting point as you begin test engraving this material. Use your lasers software settings for stamp mode or 3D effects mode. Adjust