SR20 coolant neck spacer Weld In Plates There are four options to

There are four options to choose from

- For race cars only however no permanent modifications are required

the lower arm will now be pointing slightly upwards which will lower the roll center (which is the point at which the car rolls about) this gives the car leverage and makes it easier for the car to roll from side to side

3 stud wheels

SR20 coolant neck spacer Weld In Plates There are four options toWant to install an aftermarket coolant temp sensor but don't want to cut into your radiator hose? Me either! Instead of doing that simply unbolt your factory coolant neck and install this spacer in between the neck and the head. The spacer has the provision for a 1 8 NPT provision or alternatively if used in conjunction with a barbed fitting this spacer could be used as the source for a coolant breather tank. Lightweight T6 6061 billet aluminium