Milescraft Joint Master (Metric) 1384 ONEID_OVER_18 a smaller version of the

a smaller version of the Sneeboer pointed spade

Thread Adaptor M33 x 3

For use with Milescraft Signcrafter

The pads hold projects in place while elevating them 1-3/16″ above the work surface allowing complete access to edges while holding the project in place for painting and edge routing

Milescraft Joint Master (Metric) 1384 ONEID_OVER_18 a smaller version of theA small and adaptable doweling jig that enables woodworkers to make any dowel joint fast and correctly. It includes two retractable edge stops for quickly aligning boards. The self clamping design allows for simple setup. The JointMaster comes with three drill blocks and can create joints using the most common dowel pin sizes (6, 8, 10mm). Each hardened steel drill block is adjustable to accept and align centered dowel holes in boards ranging from